PERI TRIO is a universal panel formwork system. Panel heights are available in 2.70 m and 3.30 m, and the TRIO system can be easily adapted for concreting various monolithic structures.
Panels are available in different widths (step 30 cm) and the universal panel width is 72 cm, allowing optimized formwork quantities for each project.
- Panels can be installed vertically or horizontally for maximum versatility.
- Tie point layout without additional compensating elements.
- Easy transport and handling (panel width up to 2.40 m).
- Tie points without additional extensions.
- High stiffness and excellent load-bearing capacity with minimal deflection.
Wide range of applications, including:
- Horizontal formwork extension
- Vertical panel connections
- End closure fixing
- Concreting walls using stop-end plates
- Different corner solutions
- Combination with other formwork systems
BFD Connecting Element
- Only one connecting part is used for many tasks (BFD).
- Fixing of system accessories and components.
- Securing compensating strips (up to 100 mm).
- Vertical panel connection and inner/outer corner fixing.
- Fixing of articulated corner elements.
- Reinforcement of braces for height compensation.
TRIO TSE Shaft Stripping Element
- No change in shaft dimensions required.
- With crane assistance, the TSE element is lifted and the internal shaft size is reduced by 3 cm on each side.
- Allows the entire inner shaft formwork to be moved to the next concrete lift in one lifting operation.
- Minimizes dismantling and repositioning time.
TRIO End Closures
- Fixed using panels or the BFD element.
- Facilitates reinforcement installation.
- MF/MTF end panels can be used with or without sealing tape.
Easy Panel Cleaning
- Powder-coated TRIO component surfaces reduce concrete adhesion.
- Significantly easier and faster cleaning on site.
Aluminum TRIO is lightweight and suited for crane-independent work, with easy identification by the yellow powder coating.
TRIO panels can be supplied with different facing options to match concrete surface requirements — also available pre-assembled.
Using the spindle element, the inner formwork can be moved quickly; the minimum spindle stroke is 30 mm.
The MXK bracket system can be used as a work platform (MAXIMO and TRIO). Modular design and lightweight components ensure quick setup and high efficiency. The modular system supports pre-assembled safety components, such as an MXK shaft cage or PROKIT PMB side barrier.